TMC - 0.20 - 4mm.
Width - 750/1250/1650/1800 mm.
Weight - 5/10/25/30 MT.
Type - Single Loop & Double Loop type
Slitting Machine (Diagram)
Snubber & Pillar Table Assembly
Snubber is used for pressing the coil O.D. Snubber can be operated either hydraulically or pneumatically. Hydraulically operated pillar table facilitates the entry of sheet into straightener/leveller.
The leveler is used to level the coil to desired flatness range. The feed rolls make the entry & exit of sheet from straightener easy. The rolls can be adjusted manually, hydraulically or by motor. Rolls are hardened to HRC 55-60. Provides good abrasion resistance & long service life.
Entry or Exit Shearing is provided according to customer’s requirement. This unit is hydraulic.
The coil is cut width wise as required by the cutters provided in the slitter assembly. The slitter is provided with feed rolls for facilitating the entry & exit of sheet. Separator is provided for providing a gap between slits.
Pinch Roller / Pressure Pad & Deflector Rolls
These are used for tightening & ease the rewinding of slitted coil.
This unit rewinds the slitted coils into baby coils. Unit is provided with drive. Separator is also provided in this unit.
Coil Car- Entry & Exit
Coil Car/ Lifter eases the work of un- loading the slitted coils from Re-coiler’s Jaws. Coil Car is power driven and can move to & from on rails. Coil Car move up/down by hydraulic cylinder. For light coils, coil hanger can be used
Driven by A/C geared motor/hydraulic motor to rewind the scrap.